Find great deals on eBay for Polaris Sportsman Manual in Other Makes. Shop with Polaris Sportsman / Service Repair Manual. $ View and Download Polaris Sportsman EFI owner’s manual online. Polaris ATV Owner’s Manual. Sportsman EFI Offroad Vehicle pdf manual. Sportsman / EFI ATV Service Manual (PN ) ECopyright Polaris Sales Inc. All information contained within this publication is based .

Remove the clean out plugs located on the between vehicle center and each wheel. This, in turn, increases the amount of pinch applied to the drive belt. There should one or two distinct wear Wear from Coil bands one band inside the other. Position the shift forks up and so the the pilaris point When the switch is off, the ATV is in two-wheel drive at all times.

Check the security and surface condition of the disc. Install breather reed G into rocker cover H. Inspect the pinion gear O for chipped, broken, or missing teeth. All nuts that have a cotter pin installed must be serviced by an authorized Polaris dealer.

Remove cover bolts evenly in a cross pattern and 1. Remove the seat, release the air box cover clips, and remove the air box cover.

Polaris Sportsman Manual | eBay

No single manusl on your part is as important as following the procedures for a proper break-in. Perform all services at whichever reading is reached first. Press new bearing onto the shaft.

Janual the flame of a propane torch back and forth quickly over the area where the decal is to be applied until the surface appears slightly glossy. This manual also for: Remove the anvil bolts and separate caliper halves and remove pistons with piston pliers. Compress the mounting bracket and make sure Torque Specifications the dust seals are fully seated. Aligning the timing marks on the gears. New book looks great. We got the manual a week earlier than expected!

Never replace parts with used parts from another clutch assembly! Remove the four screws securing front rack. Install a new snap ring at this time. It is recommended that the air filter and pre filter be replaced annually. Full color wiring diagrams – Manual based on actual teardown – Exploded views – Photos, drawings, and charts.

Install clutch offset spacer s on transmission input shaft. When installing the new snap ring, open the the snap ring just far enough to go manyal the shaft, to avoid stressing the snap ring. Remove driven clutch offset spacers from the necessary to gain access to PVT outer cover.

Owner’s Manuals

Reverse meter leads if battery cable. Inspect caliper body for nicks, scratches or wear. Clean mating surface of disc and hub. Brake fluid will be forced through 4.

Apply 0W to lifters. Sportsman efi sportsmna The steering post arm bolt B points up; the rod end bolts A point down.