Browse Item # ASTMA GALFAN, ASTM A GALFAN Aluminized Steel in the MST Steel Corp. catalog including Item #,Item Name,Description,Steel Type. Find ASTMA GALFAN ASTM A GALFAN Aluminized Steel from MST Steel Corp. See the chemical composition and physical properties of ASTM A Grade CS- A Steel, find alternative materials, and connect with suppliers.

This abstract is a brief summary of the referenced standard.

The coated sheet is produced in several coating designations coating weight [mass]. Values in inch-pound aztm SI units are to be regarded separately as standard.

Item # ASTMA GALFAN, ASTM A GALFAN Aluminized Steel On MST Steel Corp.

Historical Version s – view previous versions of standard. Within the text, the SI units aatm shown in brackets. Structural steel and high strength low alloy steel are available in several grades based on mechanical properties.

Coating shall conform to the coating weight according to triple-spot test and single-spot test and shall be capable of bending without flaking. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Link to Active This link will always route to the current Active version of the standard. These notes and footnotes, excluding tables and figures, shall not be considered as requirements of this specification. The Zn-5Al alloy coating also contains small amounts of elements other than zinc and aluminum that are intended to improve processing and the characteristics of the coated product. Material is classified in terms of the base metal and in terms of the coating.

Item #: ASTMA875 GALFAN ASTM A875 GALFAN Aluminized Steel

Base metal material classification is as follows: Structural steel grade 50 [] is available in three classes based on tensile strength. Therefore, each system shall be used independently of the other. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

Structural steel shall conform to the asm yield strength, tensile strength, and elongation. These notes and footnotes, excluding tables and figures, shall not be considered as requirements of this specification. Coated sheet is produced in several coating designations coating weight [mass]. Link to Active This link will always route to the current Active version of the standard.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The Zn-5Al alloy coating also contains small amounts of elements other than zinc and aluminum that are intended to improve processing and the characteristics of the coated product. This standard does not purport to address all of the safety concerns, if any, associated with its use.

Values in inch-pound and SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. Active view current version of standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the atsm.

Therefore, each system shall be used independently of the other. This specification covers steel sheet, in coils and cut lengths, metallic-coated by the hot-dip process, with zinc-aluminum alloy coating.

ASTM A875 Grade CS-A

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

The coating is produced as two types: The values stated in each system are not exact equivalents. The values stated in each system are not exact equivalents. The coated sheet is produced in several coating designations coating weight [mass]. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.