The GIOTTO series surface wall-mounted monitor in ABS is supplied with a fixing bracket with terminal Elvox Two-Wire audio/video door entry systems. CN1). Connector for electronic unit. CN2). Connector for programmer type C. B2). 2-wire Bus (cable riser). B1). 2-wire Bus (cable riser). EXT+). External. Elvox Sound System Installation and Technical information 5 12 GIOTTO AND SERIES MONITORS ® GIOTTO SERIES MONITORS.
|Country:||Turks & Caicos Islands|
|Published (Last):||26 November 2007|
|PDF File Size:||11.55 Mb|
|ePub File Size:||7.69 Mb|
|Price:||Free* [*Free Regsitration Required]|
Power is supplied from the monitor or from power supply type In this way, the switchboard is excluded from the conversation but can reply to calls from other interphones. Wiring diagram of monitors in parallel type or with simultaneous switch-on Cameras are provided with removable terminal block point A.
This key disables the switchboard operation in “Disabled” mode. The entrance panels can be coupled with the button-only series directly in the factory. To make a call from the interphones to the switchboard, lift the interphone and press the pushbutton. Elvox have recently introduced their series front panels.
When a visitor presses a push-button on the entrance panel, an acoustic signal is emitted in the corresponding apartment; the image of the person who made the call appears almost instantaneously on the monitor.
Entrance panel C1 and outdoor C2 calls are F generated by power supply typewhile intercommunicating C3 calls are routed by switch type A. The connections between the power supply elvpx the switching module and between the switching modules, if there is more than one speech unit, are facilitated by the 2 sets of wiring supplied: Call tone generator output with intermittent tone.
Output for connection of 75 Ohm video cable or 75 Ohm resistor in last monitor in systems with coax cable. The two monitors switch on simultaneously when called. Connect jumpers between terminals V1 and R1 and V2 and 630 on the last distributor.
The sound signal has two different tones 630 terminals C1-C2enabling users to immediately identify which point is calling main entrance, gate, garage, etc. This panel is provided with letter-box with front opening. The power supply can power up to 70 interphones; add another power supply type for the subsequent 70 interphones.
The last video signal distributor must be loaded by Ohm resistor connected to unused terminal V. The module is used for setting the call volume to one of three levels and disabling it.
A -Connection to user without monitor B – Connection in parallel to a video door entry unit N. A timer may be used for longer activation or for stair-lighting. The first push-button terminal 7 controls the door lock release function.
This makes it possible to frame people of different heights or to position the entrance panel higher or lower than prescribed. Common interphone receiver and microphone 6: With the GN key set to N, the night interphone ringtone will sound intermittently, until the pressed keys are disactivated. ESpecial key for security screws FRemovable terminal block to facilitate camera wiring.
A- Landing call push-button If type is installed inside interphone typethe landing call cannot be used. Variations 80 and The monitor, in this case, remains switched off.
The system can only be set up without conversation privacy between user and user. In this operating state, all calls from the interphones are diverted to the night interphone, which is able to communicate with the interphones without conversation privacy. To open the lock for the entrance panel from the switchboard, press the AP push-button while the switchboard is in the external position.
To open the door lock from the night interphone, simply press the push-button. Wiring diagram of monitor self-start button It is possible to activate the video system from the monitor, using one of the additional buttons type Additional monitor type 63M7 or 63C7 is supplied on request.
This solution also makes it possible to use a single loudspeaker built into the monitor itself to produce the sound. Three main types of system can be set up: The power supply for the whole system is provided by means of a simple transformer.
Use type after the 3rd monitor elbox for a further 4 monitors. During the course of “internal” operation IE key switched to I the system maintains conversation privacy between the switchboard and the interphones, by disabling the speech unit.